Micro Matic Commercial Equipment Repair
Micro Matic commercial equipment repair across the Jacksonville metro. Component-level diagnosis, so you are not paying for a board that was never the problem.
- 18-month labor warranty
- 1 Micro Matic equipment types
- Diagnosis
- In writing, before any work
- Labor warranty
- 18-month
- Parts warranty
- 90-day
- Sealed systems
- Diagnosed by measurement, not by symptom
- 11 yrs
- Serving Northeast Florida
- All major brands
- Residential and commercial
- 18-month
- Labor warranty on every repair
- 90-day
- Parts warranty, OEM only
- In writing
- The diagnosis, before any work
Micro Matic equipment is serviced here by technicians who work it regularly rather than occasionally. This page is the Micro Matic record — what the brand builds, which lines we see, and what is documented to fail on them; the city pages below apply it where you are.
Micro Matic builds out of Odense, Denmark (US HQ Brooksville, Florida), Denmark, and has done since 1953. Work that is documented, so you know what was changed and why.
What we know about Micro Matic
Micro Matic builds out of Odense, Denmark (US HQ Brooksville, Florida), Denmark, and has been at it since 1953. That matters in the Jacksonville metro for one practical reason: it drives which parts sit on a shelf nearby and which have to be ordered in.
Micro Matic equipment we see most
- keg couplers and dispense heads
- draft towers and faucets
- CO2 / blended-gas regulators
- direct-draw and long-draw systems
Micro Matic lines we work on
Beer Dispenser & Draft System
- Pro-Line E-Series
What is documented to fail on Micro Matic
Collected from service history and from the brand's own published notices. A fault being on this list does not mean your unit has it — it means a technician arriving to a Micro Matic call already knows where to look first.
- keg coupler probe seals and O-rings leaking or sticking
- gas regulator drift causing over/under carbonation
- faucet and shank seal leaks and sticking
- direct-draw compressor / cold-plate issues causing foaming
OEM couplers, regulators and faucet parts widely stocked through Micro Matic USA and beverage distributors; sealed-system refrigerant work on direct-draw units requires an experienced technician.
Independent commercial service experienced with Micro Matic draft systems; not an authorized Micro Matic dealer.
Micro Matic equipment we repair
Each type has its own page covering every brand, Micro Matic included.
Micro Matic repair by city
The same diagnosis and the same warranty in every city we cover.
Micro Matic service, on the record
- Labor warranty
- 18-month
- 90-day on OEM parts
- Equipment types
- 1
- Micro Matic types serviced
- Cities covered
- 14
- across the Jacksonville metro
Common questions
Answered before you call.
What happens when a technician arrives?
The technician confirms the fault on the unit itself — readings taken, not assumed — then explains what failed, why, and what the repair involves before anything is replaced.
Is the repair covered by a warranty?
We stand behind the work with an 18-month labor warranty and 90-day parts warranty — a recurrence in that time gets fixed again at no cost.
Do you use OEM parts?
We fit OEM parts wherever the repair calls for them. Where a manufacturer part is discontinued we say so, and explain what the alternative is before fitting it.
When is a replacement the better call?
Yes. Some failures cost more to put right than the remaining life of the unit justifies, and a technician who has just measured the fault is the person best placed to tell you which case you are in.
Book a repair in Jacksonville.
The fault confirmed on the unit before anything is replaced, and an 18-month labor warranty on the repair.